{
    "dataType": "CVE_RECORD",
    "dataVersion": "5.2",
    "cveMetadata": {
        "cveId": "CVE-2026-74555",
        "assignerOrgId": "416baaa9-dc9f-4396-8d5f-8c081fb06d67",
        "state": "PUBLISHED",
        "assignerShortName": "Linux",
        "dateReserved": "2026-08-15T05:44:03.916Z",
        "datePublished": "2026-08-15T12:28:00.729Z",
        "dateUpdated": "2026-08-19T16:38:54.912Z"
    },
    "containers": {
        "cna": {
            "providerMetadata": {
                "orgId": "416baaa9-dc9f-4396-8d5f-8c081fb06d67",
                "shortName": "Linux",
                "dateUpdated": "2026-08-19T16:38:54.912Z"
            },
            "descriptions": [
                {
                    "lang": "en",
                    "value": "In the Linux kernel, the following vulnerability has been resolved:\n\nscsi: libsas: Fix HA resume deadlock and hisi_sas disk-wake race\n\nCommit fbefe22811c3 (\"scsi: libsas: Don't always drain event workqueue\nfor HA resume\") introduced sas_resume_ha_no_sync() to avoid a deadlock:\nthe PHYE_RESUME_TIMEOUT handler, running on the HA event workqueue,\ncalls sas_deform_port() -> sas_destruct_devices(), which removes SCSI\ndevices and waits for the host to become runtime-active. But the host\ncannot resume until sas_resume_ha() -> sas_drain_work() returns, and the\ndrain is blocked on that very handler.\n\nHowever skipping the drain reintroduces a race: hisi_sas returns from\nresume before all PHY UP work and libsas discovery work finish. The\ncontroller may then autosuspend while disks are still waking up. The\ndisks issue IO to a suspended controller, the IO fails, and the disks\nget disabled.\n\nFix the deadlock at its source by moving the PHYE_RESUME_TIMEOUT\nnotification to after sas_drain_work(). By then the host resume is about\nto complete, so device removal through device_link no longer blocks on\nthe resume and the cycle is broken.\n\nWith the deadlock gone, restore sas_resume_ha() (the draining variant)\nin hisi_sas and remove sas_resume_ha_no_sync().\n\nThe reorder is safe for the other libsas consumers (isci, pm8001,\naic94xx, mvsas). During suspend, sas_suspend_devices() calls\nsas_notify_lldd_dev_gone() for each device, which sets dev->lldd_dev to\nNULL. When scsi_unblock_requests re-enables I/O in resume, any I/O to a\ntimed-out phy's disk is immediately rejected by the LLDD before reaching\nhardware: isci returns SAS_DEVICE_UNKNOWN (mapped to DID_BAD_TARGET),\nand pm8001 returns SAS_PHY_DOWN (mapped to DID_NO_CONNECT). Both\ncomplete directly via scsi_done() without entering SCSI EH. This is\nidentical in both the old and new ordering since lldd_dev_gone runs\nduring suspend, before resume. The reorder only affects when the\nPHYE_RESUME_TIMEOUT handler runs (synchronized by sas_drain_work()\nvs. asynchronous after resume returns), not whether I/O can reach the\ndevice. aic94xx and mvsas do not register any PM ops and never reach\nthis code path."
                }
            ],
            "affected": [
                {
                    "product": "Linux",
                    "vendor": "Linux",
                    "defaultStatus": "unaffected",
                    "repo": "https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git",
                    "programFiles": [
                        "drivers/scsi/hisi_sas/hisi_sas_v3_hw.c",
                        "drivers/scsi/libsas/sas_init.c",
                        "include/scsi/libsas.h"
                    ],
                    "versions": [
                        {
                            "version": "fbefe22811c3140a686e407e114789ebf328a9a2",
                            "lessThan": "09357f067122e2e28ec52e27013a1660a1571618",
                            "status": "affected",
                            "versionType": "git"
                        },
                        {
                            "version": "fbefe22811c3140a686e407e114789ebf328a9a2",
                            "lessThan": "e50a6523a603594a6d92cdecfe11997d639410a3",
                            "status": "affected",
                            "versionType": "git"
                        },
                        {
                            "version": "fbefe22811c3140a686e407e114789ebf328a9a2",
                            "lessThan": "c391b5899dd46485a5893696c12ae3e95a3a7325",
                            "status": "affected",
                            "versionType": "git"
                        },
                        {
                            "version": "fbefe22811c3140a686e407e114789ebf328a9a2",
                            "lessThan": "9e24b47ef81d43b3fb1b14294f09991640c79fcc",
                            "status": "affected",
                            "versionType": "git"
                        },
                        {
                            "version": "fbefe22811c3140a686e407e114789ebf328a9a2",
                            "lessThan": "b9c44a14062093e9fc2d6bddc696cfceadb482d7",
                            "status": "affected",
                            "versionType": "git"
                        },
                        {
                            "version": "fbefe22811c3140a686e407e114789ebf328a9a2",
                            "lessThan": "3dbbbf656b850c9c8de05df6ad4a1dfc6ff02845",
                            "status": "affected",
                            "versionType": "git"
                        }
                    ]
                },
                {
                    "product": "Linux",
                    "vendor": "Linux",
                    "defaultStatus": "affected",
                    "repo": "https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git",
                    "programFiles": [
                        "drivers/scsi/hisi_sas/hisi_sas_v3_hw.c",
                        "drivers/scsi/libsas/sas_init.c",
                        "include/scsi/libsas.h"
                    ],
                    "versions": [
                        {
                            "version": "5.17",
                            "status": "affected"
                        },
                        {
                            "version": "0",
                            "lessThan": "5.17",
                            "status": "unaffected",
                            "versionType": "semver"
                        },
                        {
                            "version": "6.1.183",
                            "lessThanOrEqual": "6.1.*",
                            "status": "unaffected",
                            "versionType": "semver"
                        },
                        {
                            "version": "6.6.151",
                            "lessThanOrEqual": "6.6.*",
                            "status": "unaffected",
                            "versionType": "semver"
                        },
                        {
                            "version": "6.12.103",
                            "lessThanOrEqual": "6.12.*",
                            "status": "unaffected",
                            "versionType": "semver"
                        },
                        {
                            "version": "6.18.44",
                            "lessThanOrEqual": "6.18.*",
                            "status": "unaffected",
                            "versionType": "semver"
                        },
                        {
                            "version": "7.1.8",
                            "lessThanOrEqual": "7.1.*",
                            "status": "unaffected",
                            "versionType": "semver"
                        },
                        {
                            "version": "7.2",
                            "lessThanOrEqual": "*",
                            "status": "unaffected",
                            "versionType": "original_commit_for_fix"
                        }
                    ]
                }
            ],
            "cpeApplicability": [
                {
                    "nodes": [
                        {
                            "operator": "OR",
                            "negate": false,
                            "cpeMatch": [
                                {
                                    "vulnerable": true,
                                    "criteria": "cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*",
                                    "versionStartIncluding": "5.17",
                                    "versionEndExcluding": "6.1.183"
                                },
                                {
                                    "vulnerable": true,
                                    "criteria": "cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*",
                                    "versionStartIncluding": "5.17",
                                    "versionEndExcluding": "6.6.151"
                                },
                                {
                                    "vulnerable": true,
                                    "criteria": "cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*",
                                    "versionStartIncluding": "5.17",
                                    "versionEndExcluding": "6.12.103"
                                },
                                {
                                    "vulnerable": true,
                                    "criteria": "cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*",
                                    "versionStartIncluding": "5.17",
                                    "versionEndExcluding": "6.18.44"
                                },
                                {
                                    "vulnerable": true,
                                    "criteria": "cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*",
                                    "versionStartIncluding": "5.17",
                                    "versionEndExcluding": "7.1.8"
                                },
                                {
                                    "vulnerable": true,
                                    "criteria": "cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*",
                                    "versionStartIncluding": "5.17",
                                    "versionEndExcluding": "7.2"
                                }
                            ]
                        }
                    ]
                }
            ],
            "references": [
                {
                    "url": "https://git.kernel.org/stable/c/09357f067122e2e28ec52e27013a1660a1571618"
                },
                {
                    "url": "https://git.kernel.org/stable/c/e50a6523a603594a6d92cdecfe11997d639410a3"
                },
                {
                    "url": "https://git.kernel.org/stable/c/c391b5899dd46485a5893696c12ae3e95a3a7325"
                },
                {
                    "url": "https://git.kernel.org/stable/c/9e24b47ef81d43b3fb1b14294f09991640c79fcc"
                },
                {
                    "url": "https://git.kernel.org/stable/c/b9c44a14062093e9fc2d6bddc696cfceadb482d7"
                },
                {
                    "url": "https://git.kernel.org/stable/c/3dbbbf656b850c9c8de05df6ad4a1dfc6ff02845"
                }
            ],
            "title": "scsi: libsas: Fix HA resume deadlock and hisi_sas disk-wake race",
            "x_generator": {
                "engine": "bippy-1.2.0"
            }
        }
    }
}